After cutting the retaining plates by pressing the machine, acidifies and cleans the plates to be prepared for subsequent gluing.
At this stage, the required powder materials, mixed in definite and exact percentages, are remixed again to homogenize.
B/Plate treatment (Adhesive)
At this stage, the adhesive material is applied to the retaining plate to be used in the next step for the molding of powder materials.
The holder of the plates
At this stage, the plates are compressed under a certain pressure and kept in the retainer to be bake at the next stage.
Burning powder materials for purification
During a certain time and temperature, the retaining plate, along with the powdered material injected onto it, passes through the furnace so that the volatile matter inside the powder material is lost and the resin is internally polymerized to increase the strength of the powdered material.
Semi auto forming & Auto forming M/C
Using the mold, the powder material of the lining is injected onto the retaining plate and compressed
Burning lining surface
At this stage, to improve the final quality, the uniformity of the conditions during the load on the outer surface of the plates takes place and for a certain period the surface temperature reaches approximately 500 degrees, which increases the surface quality and reduces the initial sound of the lining during operation.
Machine-building and stone-cutting
At this stage, the raw linings produced by the use of machining and grinding processes to increase the final quality of production in accordance with the dimensions of the map becomes final.
A series of processes required for the production of laths in this line are made seamlessly and separately from other lines, so that the lining completely starts from the beginning and ends up in the end
Painting and drying M/C
The collection is completely spray-dried at this stage